(j3.2006) (SC22WG5.5043) ts29113 compiler conformance table

[Bill Long]

Hi Ian,

You might consider adding another line for implementation of the change 
documented in paper 13-283 from the Delft WG5 meeting last month.  This 
allows a scalar actual argument to correspond to a TYPE(*),DIMENSION(*) 
dummy argument, and is needed to make the MPI module interfaces work the 
way that was intended.   I suspect that the MPI implementers will be 
most interested in the initial version of this table.

Cheers,
Bill


On 7/29/13 4:00 AM, Ian Chivers wrote:
> Here is a spreadsheet I have created concerning
>
> TS29113.
>
> Copies of the spreadsheet and Reinhold's
>
> draft paper can be found at
>
> http://rhymneyconsulting.co.uk/fortran/fortran_forum/
>
> I would be grateful if the compiler vendors on the list
>
> could fill in the table and return it
>
> and i'll include their replies in the december edition
>
> of fortran forum.
>
> please correct the spreadsheet if there are any errors.
>
> I will be circulating to the other vendors when i get time
>
> later today.
>
>
>
> _______________________________________________
> J3 mailing list
> J3 at mailman.j3-fortran.org
> http://mailman.j3-fortran.org/mailman/listinfo/j3
>

-- 
Bill Long                                           longb at cray.com
Fortran Technical Support    &                 voice: 651-605-9024
Bioinformatics Software Development            fax:   651-605-9142
Cray Inc./Cray Plaza, Suite 210/380 Jackson St./St. Paul, MN 55101