(j3.2006) Question about IMPLICIT

[Bill Long]

On 8/14/13 4:02 PM, Van Snyder wrote:
>
> [109:16] says
>
> "..., and the default for an internal or module procedure is the mapping
> in the host scoping unit." (This ought not to be a run-on sentence.)
>
> What's the default in a BLOCK construct?

Since you cannot put an IMPLICIT statement in the specification part of 
a BLOCK construct (C806) the implicit rules would seem to apply as if 
the BLOCK / END BLOCK were not there.  Note 5.39 pretty much says that.

Cheers,
Bill

>
>
> _______________________________________________
> J3 mailing list
> J3 at mailman.j3-fortran.org
> http://mailman.j3-fortran.org/mailman/listinfo/j3
>

-- 
Bill Long                                           longb at cray.com
Fortran Technical Support    &                 voice: 651-605-9024
Bioinformatics Software Development            fax:   651-605-9142
Cray Inc./Cray Plaza, Suite 210/380 Jackson St./St. Paul, MN 55101