(j3.2006) N1718 prepared

Bill Long longb
Tue Feb 19 19:47:13 EST 2008


Van Snyder wrote:
> I printed some pages at 100% from acrobat (selected "None" from the
> "Page Scaling" menu).  If I select "Auto Rotate and Center" the header
> is only halfway onto the page, but if I don't select this, both the
> header and footer are on the page.
>   

I had the same experience. Thanks for the tip, Van.  If I select "fit to 
printer margins" the image gets scaled to 87%, which is still readable.

Cheers,
Bill


> The problem I had with 08-007 was caused by a too-helpful Xerox printer
> becoming convinced it had A4 paper, when it in fact had US Letter paper.
>
> Van
>
> On Tue, 2008-02-19 at 11:30 +0900, Malcolm Cohen wrote:
>   
>> Hi folks,
>>
>> N1718 aka 08-007r1 is now available in the Edit subdirectory
>> of the j3-fortran.org ftp server, as
>>    N1718.pdf.bz2
>>    N1718.ps.bz2
>> i.e. both bzip2-ed.
>>
>> It has paragraph numbers but no line numbers.
>>
>> It is formatted for A4 but should print ok on Letter according to
>> the experiments I did while I was at the meeting.  You might get
>> better output by using the PDF and actually telling AcroRead that
>> you are printing on Letter (that's what I found anyway).
>>
>> (During my experiments I convinced AcroRead to print it at 100%
>> resolution and at that time all the toner still ended up on the page
>> and not too close to the binding margin, but just taking the normal
>> defaults looked better so I don't recommend that unless you know what
>> you are doing.)
>>
>> Perhaps someone (Van?) could print a couple of pages as a final check
>> on printability: unless something has gone badly wrong I will move it
>> to 08-007r1 tomorrow.
>>
>> Cheers,
>>     
>
> _______________________________________________
> J3 mailing list
> J3 at j3-fortran.org
> http://j3-fortran.org/mailman/listinfo/j3
>   


-- 
Bill Long                                   longb at cray.com
Fortran Technical Support    &              voice: 651-605-9024
Bioinformatics Software Development         fax:   651-605-9142
Cray Inc., 1340 Mendota Heights Rd., Mendota Heights, MN, 55120

            




More information about the J3 mailing list